one product Two Applications
one product Two Applications
THE CHALLENGE WAS TO CREATE AN INNOVATIVE DEVICE THAN CAN MEET THE FOLLOWING CHARACTERISTICS:
– capable to hold FO cable in two different locations (Network cable + Drop Customer cable);
– capable to install a Fiber Distribution Outdoor Box (up to 168FO);
– produced in non-conductive material;
– resistant to local weather conditions;
– UV resistant;
– light material that allows easy installation;
– easiness of storage, transportation and assembly;
– Low cost
The Cable Slack Holder is assembled without tools, screws and nuts.
Like a puzzle the arms are assembled the main structure and complete the main assembly with a Stainless-Steel band.
However, if customer requirement, the arm has a position to assemble a type M4 screw with a nut, this option is available.
Produced by plastic injection molding (ASA), the Cable Slack Holder is designed to hold fiberoptic cable in two different locations.
The external part will hold the Network fiberoptic cable and an internal section will hold the Customer Drop cable.
The Cable Slack Holder maintains the minimum bending radius of the cables, preventing macro and micro bending’s on the fibres, allowing consistency and regularity in the fibre loops.
The Cable Slack Holder is designed to support, not only the slack of cable, but also FO termination equipment.
This termination equipment can be:
– Customer Connection point up to 96FO
– Network Splice Closure up to 168FO
C3T TECHNOLOGIES
Head Office
Aveiro Business Center
Rua da Igreja nº 79
3810-744 Aveiro – Portugal
Main Warehouse
Rua Frei João Turiano 13
2675-389 Odivelas – Portugal